Description

This is a classic green goniopora from Australia we imported around 2018. The coral has been growing great and is as close to a bullet proof goni as you can get. Doc likes to add these to many of our custom reef tank designs. Place it with other variations of gonioporas to form a garden of mixed colors.

Troubleshooting: If the coral polyps are not opening and the other corals seem fine then it is most likely too much flow or someone is picking on it. Certain fish can single out one LPS in the tank and constantly pick at it throughout the day while leaving all others alone.

Flatworm pests can infect certain LPS corals. Coral dipping helps. We like to use various coral dipping solutions or Melafix.

Care level: intermediate and up

Flow: medium high to medium low

PAR: 100-250, will handle up to 4350nm with no issues

Original Location Range: Indonesia, Coral Triangle, South Pacific

Grown in our California coral farm providing zero impact corals

Water chemistry: Calcium 400-450, Magnesium 1350, KH 7-9.5, pH 8.1-8.4, Nitrates .01-10+, Phosphates .01-.1, salinity 1.026

Temperature Range: 74- 81 Fahrenheit

Feeding: these corals can be target or broadcast fed. They will feed on smaller soaked pellets and will do well without direct coral feedings if there is heavy fish feedings. Target feeding is always best and be sure your coral is taking in the food and not just sliming it off.

For more information on coral foods we like to use click here.

Dosing: Doc highly recommends automated dosing of Ca, Kh and other elements to provide ultimate stable water chemistry throughout the day. It is important there are no fluctuations especially with Kh/alkalinity. For more information on dosing and products click here.

Recommended placement:

We like to plant these corals in areas with moderate flow on a stable area.

Attachment: In many of our custom aquarium builds we like to use a fair amount of epoxy to set up the fragments. It is recommended to try and break off as much of the disk safe enough not to damage the skeletal branch of the coral. We do this by using coral bone cutters to clip the base. Add a small amount of coral glue to the underside of the branch. Mix up enough two part epoxy to create a small ¾” ball and dab it a few times into the glue to get it tacky then press and mold a nice pedestal base with a flat bottom in an upside down mushroom shape. Do not get any water on the epoxy before adding the coral glue. Add a few small dabs of reef glue to the flattened base dabbing the glue so it really sticks to the epoxy. Press the coral disk onto the desired location and press the epoxy flat onto the reef. Be sure the coral is fully secure, the coral should never fall off the reef. Most frags will grow quite large so be a little generous with the epoxy to withstand the weight of the future coral colony growth. The epoxy part can be skipped using only the extra thick reef glue gel. Be sure to rub a little reef glue onto the reef section and there is enough reef glue on the coral plug to set it securely.

Click here for our favorite epoxy and reef glues.